Datapath Vision VisionRGB-E2S - Video capture adapter - PCIe x4

The VisionRGB-E2S, a stand alone PCI Express x4 plug in capture card, delivers extreme performance with 650 MB/s transfer bus bandwidth providing a further improvement to the 480 MB/s of the VisionRGB-E2. The VisionRGB-E2S captures the Analog/DVI data and triple buffers it into onboard storage. This data is then copied using DMA to the host system for display, storage or streaming.
When a Datapath graphics card is used, the VisionRGB-E2S transfers the data directly to the graphics card thereby increasing performance. The VisionRGB-E2S capture card sends the relevant portions of each channel to use its graphics engine to render the data. This fully utilizes the hardware and dramatically increases performance.
When the RGB/DVI data is displayed on a non Datapath graphics card, the VisionRGB-E2S sends the data to system memory or direct to the graphics card, dependant on the software used for display.

• High performance DMA to system memory or direct to graphics memory with scatter gatherClick to enlarge
• On board processor for real time mode and sync detection
• When used with the Datapath range of graphics card adapters, the CPU load is negligible even if the image is being upscaled to a video wall, resulting in real time performance
• Dynamic input source selection
• Administrator mode
• Update indicator

The VisionRGB-E2S, a stand alone PCI Express x4 plug in capture card, delivers extreme performance with 650 MB/s transfer bus bandwidth providing a further improvement to the 480 MB/s of the VisionRGB-E2. The VisionRGB-E2S captures the Analog/DVI data and triple buffers it into onboard storage. This data is then copied using DMA to the host system for display, storage or streaming.